This Kit adds channels 5-8 of ULN-R preamps to a LIO-8 that has an 8 channel DB-25 Input connector board already installed
These are the same preamps as used in the ULN-8.
| Mic Pre Input + ADC |
| Input Impedance | 3.3 kΩ |
| Dynamic Range (-60 dB, flat 0-22.05 kHz, typ) | 115 dB |
| Dynamic Range (-60 dB, A-weighted, typ) | 118 dB |
| Noise Floor (flat 0-22.05 kHz, typ) | 115 dB |
| Noise Floor (A-weighted, typ) | 117.9 dB |
| Gain Range | -22 dB to +91.5 dB |
| Gain Precision | �0.05 dB |
| Gain Step | 0.5 dB |
| THD D/A/A/D loop @ -12 dBFS | 0.0007 % |
| THD D/A/A/D loop @ -12 dBFS +12 dB Gain | 0.0015 % |
| THD D/A/A/D loop @ -0 dBFS | 0.0023 % |
| Crosstalk @ 1kHz | -110dB |
| IMD 1k component (19 kHz/20kHz @ +8dBu) | -104 dBu |
| EIN @ 60 dB Gain (150Ω Source Impedance) | -130.50 dBu |
| EIN @ 60 dB Gain (0Ω Source Impedance) | -133.25 dBu |
| Analog Send Calibration (ADC = 0 dBFS) | +21.5 dBu |
| Phantom Power (Switchable Per Channel) | +48 Volts |
| Mic Pre + ADC Frequency Response |
| +0/-0.1dB @ fs = 44100 Hz | 8.9 Hz - 20.5 kHz |
| +0/-1.0dB @ fs = 44100 Hz | 2.9 Hz - 21.0 kHz |
| +0/-0.1dB @ fs = 96000 Hz | 8.9 Hz - 43.9 kHz |
| +0/-1.0dB @ fs = 96000 Hz | 2.9 Hz - 45.4 kHz |
| +0/-0.1dB @ fs = 192000 Hz | 8.9 Hz - 42.1 kHz |
| +0/-1.0dB @ fs = 192000 Hz | 2.9 Hz - 64.7 kHz |
| 5� low-end in-channel phase deviation point | 20.0 Hz |
| Interchannel phase 0 Hz - 20 kHz | < �0.05� |
| Crosstalk from SMPTE Input | < -142 dB |
